Midsize Truck Owners Forum

Midsize trucks. Payload stickers, real mpg, and what you paid.

Home/Mods, tires & towing/Leveling kit and 33s, what rubs

leveling kit and 33s on a midsize, what actually rubs and when to re-gear

TRL-07Opened by colorado_zr2_ownerNov 13, 2025in Mods, tires & towing7 posts
colorado_zr2_ownerOP Backroad regular #1
Durango, CO38 posts · joined Nov 20252020 Colorado ZR2 3.6, 285/75R17

thinking about going to a true 33 on the ZR2 and i keep getting three different answers depending on who is trying to sell me parts. truck is a 2020 Colorado ZR2, 3.6, and it already has the roughly 2 inches the ZR2 comes with from the factory plus the DSSV shocks. it is on 285/70R17 now, which is basically a 32.7.

if i step up to a real 33 (285/75R17 or a 255/80R17) what actually rubs at full lock, do i need to trim the front bumper corners or just the mud flaps, and what does it do to the speedo and the shift points. and the one nobody answers straight: at what tire size do i have to re-gear the 3.42 to stop feeling like i am towing an anchor. i am not a rock crawler, i pull a small trailer and run forest roads. load ratings for the class are on bfgoodrichtires.com and i am leaning KO2 in a C load to keep the weight down.

towing_a_dirtbike Gravel miles #2
St George, UT29 posts · joined Nov 20252020 Tacoma TRD Off-Road 3.5, 33s

i went 33s on a Tacoma, which is a tighter truck up front than your Colorado, so take mine as the worst case. 285/75R17 KO2 on a 1.5 inch lift. at full lock the leading edge of the tire kissed the plastic cab-mount pinch weld and the mud flap, i cut the flap, rolled nothing, and it quit. you will have more room than me.

the speedo is the part people wave off. going from a 32 to a 33 put my dash 3 mph slow at 70, which sounds like nothing until you realize your odometer is reading short too and every mpg and mileage number you log is now wrong. get it recalibrated, a tuner or the dealer will do it. and yes, re-gear. a 3.5 pound-heavier tire on stock gears with a trailer behind you means hunting on every grade, and the trans temp and the fuel both hate that.

frontier_pro4x Gravel miles #3
Enid, OK26 posts · joined Nov 20252022 Frontier Pro-4X 3.8

Frontier guy, so a little different, but the Pro-4X comes on 265/70R17 and people jump straight to 285s. the thing i learned the hard way is load range. everybody buys an E load tire because it looks serious and then whines that the ride went to rock and the mpg fell off, on a truck that weighs 4,700 lbs and never carries a load that needs an E. a C, or even the stock standard load, is plenty for a half ton of camping gear. an E load 285 was built for a 3/4 ton. the ZR2 has the right idea running a C.

bed_length_debate High clearance #4
Chico, CA44 posts · joined Nov 20252017 Tacoma SR5 V6, 6 ft bed

what i tell everybody before they spend the money: measure your real rubbing before you buy a lift. a lot of 'i need a lift for 33s' is really 'i need to trim a mud flap and roll one fender.' i run a 265/75R16 on a stock-height 2017 Tacoma and it clears with a flap trim and nothing else. a leveling kit mostly buys you the look and a little room for a taller tire up front, it does not add any real suspension travel. the ZR2 already has good travel from the factory, so you may be stacking lift you do not need and wrecking your alignment angles to get it.

colorado_zr2_ownerOP Backroad regular #5
Durango, CO38 posts · joined Nov 20252020 Colorado ZR2 3.6, 285/75R17

ordered the 285/75R17 KO2 in a C load like a couple of you said, and i am re-gearing to 3.73 while the truck is on the rack, since the ZR2 came with the 3.42 and the front e-locker. a shop in Durango quoted the gears and a speedo recal together.

test fit before the gears went in: at full lock the tire brushed the front edge of the rear fender liner and the mud flap bracket, nothing on the bumper. trimmed the flap, pulled the liner edge back a quarter inch, done. you were right that the Colorado has more room than a Tacoma. the ride on the C load is honestly fine, the fellow who warned me off the E load was dead on, my buddy's E load 285s on his Frontier ride like a buckboard on a dirt road.

real_world_mpg Backroad regular #6
Idaho Falls, ID35 posts · joined Nov 20252021 Ranger XLT 2.3, 4x4

tagging the fuel cost onto this since i live in the mpg thread. every inch of tire and every pound of it costs you. my Ranger on the stock 265/65R17 gets 19.4. i ran a buddy's take-off 285/70 for a month and dropped to 17.6, and the truck felt slower off the line even though the tire was only an inch and a half taller. rotating mass is the enemy. if you are not going to re-gear, do not go past a 32 on a stock midsize or you will spend the highway miles hating it.

mod_deon_r Moderator #7
Carson City, NV61 posts · joined Nov 20252018 Tacoma TRD Sport 3.5, 6-speed

alignment shop hat on. when you lift and go big, two things get skipped and both of them eat tires. one, caster. a leveling kit tips the top of the strut back and you lose caster, the truck wanders and the steering goes light, and you want the shop to put caster back with the adjusters or a caster plate, not just set toe and send it. two, after a re-gear and a bigger tire, go back and reset toe to zero or a hair in, because a feathered edge on a fresh 400 dollar tire will make a grown man quiet. and recalibrate the speedo. i have watched a customer argue a ticket because his dash read 65 and the radar did not agree.

Log in to reply. No account yet? ask a mod, it takes a day or two.

Also worth reading

Thread tags

  • leveling kit
  • 33s
  • re-gear
  • load range
  • speedo